Maximum Vigilant User Manual download pdf

VIGILANT

INSTALLATION

PROPER INSTALLATION IS IMPORTANT. IF YOU NEED ASSISTANCE, CONSULT A CONTRACTOR

ELECTRICIAN OR TELEVISION ANTENNA INSTALLER (CHECK WITH YOUR LOCAL BUILDING SUPPLY,

OR HARDWARE STORE FOR REFERRALS). TO PROMOTE CONFIDENCE, PERFORM A TRIAL

WIRING BEFORE INSTALLATION.

Feed the teminal lug end of the 2-conductor cable

through the rubber boot and connect the lugs to the

terminals on the bottom of the wind speed sensor.

(DO NOT adjust the nuts that are already on the

sensor). The polarity does not matter.

Slide the stub mast through the rubber boot and insert

the stub mast into the bottom of the wind speed sensor.

Secure with the cotter pin. Coat all wire connections

with silicone sealant and slip the boot over the sensor.

Secure the sensor and the stub mast to your

antenna mast (not supplied) with the two hose clamps.

Radio Shack and similar stores have a selection of

antenna masts and roof mounting brackets. Choose

a mount that best suits your location and provides at least

eight feet of vertical clearance above objects on the roof.

Determine where you are going to locate both the rooftop

sensor and the read-out.

2-CONDUCTOR

CABLE

BOOT

COAT NUTS

WITH SEALANT

WIRE

BOOT

COTTER

HOSE CLAMPS

MAST

Follow the instructions supplied with the antenna

mount and secure the mast to the mount.

8 FEET

CHIMNEY

MOUNT

VENT-PIPE

MOUNT

TRIPOD

MOUNT

WALL

MOUNT

EVE

MOUNT

DRIP

LOOP

CAULK

WIRE

Secure the wire to the building using cable clips (do not use

regular staples). Form a drip loop where the wire enters the

hole drilled through exterior wall. Caulk the hole when done.

CABLE

CLIPS

Feed the cable through the wall to where the read-out is going

to be located. Attach the wires to the rear of the read-out as

shown. (Do NOT adjust the nuts that are already on the meter).

The polarity does not matter.

Mount the read-out directly over the cable feed-thru-hole

to avoid crimping the wire under the lip. We recommend

mounting the read-out on one of our pre-drilled and

centered wood panels.

WIRE

WIRE-HOLE

WOOD

PANEL

WIRE

SCREW

WALL

Samuel Barnett Boulevard

New Bedford, MA 02745

(508) 995-2200

1 2 3 4

VIGILANT 1

Summary of Contents

Page 1 - VIGILANT

VIGILANTINSTALLATIONPROPER INSTALLATION IS IMPORTANT. IF YOU NEED ASSISTANCE, CONSULT A CONTRACTOR ELECTRICIAN OR TELEVISION ANTENNA INSTALLER (CHECK

Page 2

VIGILANTOPERATIONTROUBLE SHOOTINGADDITIONAL INFORMATIONTo reset the gust register needle,turn the knob counter-clockwise.The Vigilant is a self-powere

Page 3

IMPORTANT ADDITIONAL INFORMATION Components: Along with the indicator, the following components are included with this instrument:

Page 4

30 SAMUEL BARNET BOULEVARD  NEW BEDFORD, MASSACHUSETTS 02745 U.S.A. TEL. 508.995.2200  WWW.MAXIMUM-INC.COM  FAX 800.989.2580 Electrical Damage

Comments to this Manuals

No comments

Maximum Vigilant User Manual

Browse online or download User Manual for Measuring instruments Maximum Vigilant. Maximum Vigilant User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Measuring instruments Maximum Vigilant