Maximum Mini-Max Operations Instructions download pdf

MINI-MAX

INSTALLATION

PROPER INSTALLATION IS IMPORTANT. IF YOU NEED ASSISTANCE, CONSULT A CONTRACTOR, ELECTRICIAN

OR TELEVISION ANTENNA INSTALLER (CHECK WITH YOUR LOCAL BUILDING SUPPLY, OR HARDWARE STORE

FOR REFERRALS). TO PROMOTE CONFIDENCE, PERFORM A TRIAL WIRING BEFORE INSTALLATION.

30 Samuel Barnett Boulevard

New Bedford, MA 02745

(508) 995-2200

Form a drip loop with the wire at least eight inches

below the exit from the sensor and at least eight inches

below the point of entry into the building. Anchor any

exposed wire with insulated cable clips. Run the wire

through the building to the location where the indicator

will be located. Caulk any holes when done.

Mount the Brass Readout directly over the Feed-Thru-Hole

to avoid crimping the wire under the lip. We recommend

mounting the Readout on one of our pre-drilled and

centered panels.

Unplug the AC adaptor and disconnect the wires. Mystic is now ready for the final installation.

The adjustment that you have made will always remain intact.

Mount the temperature sensor assembly with the two

large wood screws. Select a location that is protected

from direct sunlight and sheltered. (A north exposure, six

feet above the ground will give the best results.)

DRIP

LOOP

WOOD

SCREWS

CAULK

CABLE

CLIP

MIN

GREEN

GROUNDING

CORD

GREEN

GROUNDING

CORD

TEMPERATURE

SENSOR

ADAPTOR

CABLE-HOLE

WALL

SCREW

LUG

SCREW

PRE-DRILLED PANEL

To prevent static from causing bad readings it is necessary to

"EARTH GROUND" you Mini-Max. Proceed as follows:

-Turn off the circuit-breaker to the outlet where the ground cord

is attached.

-Remove the outlet cover screw.

-Insert the outlet cover screw through the lug on the green

grounding cord and reinsert the outlet cover screw.

-Turn on the circuit-breaker to the outlet.

-Plug in the AC Adaptor.

-Reset the memories as described in the operating instructions

(next page).

Feed the AC Adaptor Cord, Green Grounding Cord and Sensor

wire to the Indicator. Connect the two temperature sensor wires

to the appropriate terminals (HEX NUTS) as shown in the

illustration. The polarity does not matter. Connect the AC adaptor

wires to their appropriate terminals (HEX NUTS) as shown in the

illustration. The polarity does not matter for these.

1 2 3 4 5

Summary of Contents

Page 1 - MINI-MAX

MINI-MAXINSTALLATIONPROPER INSTALLATION IS IMPORTANT. IF YOU NEED ASSISTANCE, CONSULT A CONTRACTOR, ELECTRICIAN OR TELEVISION ANTENNA INSTALLER (C

Page 2

Unplug the AC adaptor and disconnect the wires. Mystic is now ready for the final installation.The adjustment that you have made will always remain i

Page 3 - MINI-MAX

TROUBLE SHOOTING Unplug the AC adaptor and remove the instrument from the wall. 1Disconnect the AC adaptor from the indicator and connectit to an A

Page 4

IMPORTANT ADDITIONAL INFORMATION Components: Along with the indicator, the following components are included with this instrument:

Page 5 - Recommended Prevention:

30 SAMUEL BARNET BOULEVARD  NEW BEDFORD, MASSACHUSETTS 02745 U.S.A. TEL. 508.995.2200  WWW.MAXIMUM-INC.COM  FAX 800.989.2580 Electrical Damage

Comments to this Manuals

No comments

Maximum Mini-Max Operations Instructions

Browse online or download Operations Instructions for Weather stations Maximum Mini-Max. Maximum Mini-Max Operating instructions User Manual

Summary of Contents

Comments to this Manuals