Maximum Wireless Merlin, Mystic & Rainwatch (pre-2006) User Manual

Installation Instructions I. Introduction Thank you for purchasing a Maximum Wireless Weather instrument. Maximum Wireless Instruments are des

A. Receivers (cont.) 2. Rainwatch - Connect the Yellow wire from the receiver to terminal #4 of the Rainwatch. - Connect the Brown wire from th

Jumper Normal Position Test Position Diagram B 3. Wind Transmitter - Insert two AA NiCad batteries (supplied) into the

3. Wind Transmitter (cont.) - Remove the bottom portion of the black bracket on the back of the Wind transmitter case, by loosening the four black

A. Instrument Display (cont.) - The following should display on each instrument upon power-up: o Merlin: all LEDs will illuminate, then “0” will

D. Wind Transmitter - Once fully charged, remove the NiCad batteries from the battery charger, and install them into the Wind transmitter. o The

VII. Battery Information - The AA alkaline batteries in the Temperature and Rain Collector transmitters should last from 1 – 2 years depending

X. Information for the Wireless Instrument user Warning: Changes or modifications to this unit not expressly approved by the party responsible for c